Emptying The Punch Waste Container (For Finisher-B1) - Fuji Xerox apeosport-iv C5570 Administrator's Manual

3 Maintenance

Emptying the Punch Waste Container (for Finisher-B1)

When the optional Finisher-B1 is installed and the hole punch waste container
becomes full, a message appears on the touch screen. When the message appears,
empty the hole punch waste container as instructed.
Make sure to discard all paper chads when emptying the hole punch waste container.
Not doing so will cause the container to fill up before the message telling you to empty
the container appears again, and this can cause machine malfunction.
Important • Empty the hole punch waste container when the machine is on. If you empty the container
1
Make sure that the machine is not operating,
lift the top transport cover, and then open the
front transport cover of the finisher.
3
2
Pull out the hole punch waste container.
3
Empty the container.
4
Insert the emptied hole punch waste
container into the finisher until it stops.
5
Close the front transport cover, and then close the top transport cover of the finisher.
Note
76
while the machine is off, the machine does not recognize that the container has been
emptied.
• If the cover is not completely closed, a message will appear and the machine remain
paused.