Fuji Xerox apeosport-iv C5570 Administrator's Manual page 525

Category
Error Code
C P F S M O
133-280
O
133-281
133-282
133-283
133-700 O
133-710
O
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
Cause and Remedy
[Cause] An error occurred during fax transmission.
[Remedy] Switch off the machine power, make sure that the touch
screen is blank, and then switch on the machine power. If
the error still is not resolved, contact our Customer
Support Center.
[Cause] The staple/hole punch setting was cancelled.
[Remedy] Check whether the staple/hole punch position is correct,
and then execute the operation again.
[Cause] When printing the received fax document, the paper
loaded on the bypass tray was used for printing because
the specified tray could not be used.
[Remedy] Take one of the following measures:
Load paper available for printing the received fax
document:
A3 SEF , A4 LEF , B4 SEF , B5 LEF ,
A4 SEF , A5 SEF , B5 SEF , 8.5 x 11" SEF ,
8.5 x 13" SEF , 8.5 x 14" SEF , 11 x 17" SEF ,
8.5 x 11" LEF
Use a paper type available for printing the received fax
document:
plain paper, bond paper, recycled paper, side 2 paper,
user-defined custom paper.
Confirm the settings by selecting [Tools] > [Fax Service
Settings] > [Fax Control] > [Receiving Paper Size].
1. Select [Receiving Paper Size] > [Tray Mode] to add a
tray to be used for printing the received fax documents.
2. Set up paper so that the tray specified tray in [Tray
Mode] can be used for printing the received fax
documents.
If the error still is not resolved, contact our Customer
Support Center.
5.5 x 8.5" SEF .
,
Error Code
14
523