Fuji Xerox apeosport-iv C5570 Administrator's Manual page 510

14 Problem Solving
Error Code
C P F S M O
033-538
033-539
033-540
033-541
033-542
033-543
033-544
033-545
033-546
033-547
033-548
033-549
033-550
033-551
033-552
14
033-553
033-554
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
508
Category
O [Cause]
[Remedy] Execute the operation again. If the error still is not
O [Cause]
[Remedy] Specify the recipient correctly.
O [Cause]
[Remedy] Specify a connected line.
O [Cause]
[Remedy] Enter a correct fax number, and execute the operation
O [Cause]
[Remedy] Wait for a while, and then execute the operation again.
O [Cause]
[Remedy] Check whether the other machine is a facsimile.
O [Cause]
[Remedy] Check whether the line is connected correctly.
O [Cause]
[Remedy] No measure is required.
O [Cause]
[Remedy] Establish communication such as by telephone, and
O [Cause]
[Remedy] Wait for a while, and execute the operation again.
O [Cause]
[Remedy] Wait until the job being communicated completes, and
O [Cause]
[Remedy] Wait for a while, and execute the operation again.
O [Cause]
[Remedy] Confirm the model of the other machine, and execute the
O [Cause]
[Remedy] If necessary, check whether the sender entered an invalid
O [Cause]
[Remedy] No measure is required.
Cause and Remedy
An error occurred during fax transmission.
resolved, contact our Customer Support Center.
The recipient is not specified.
A line was specified that is not connected.
The recipient (fax number) is incorrect.
again.
The recipient's line is busy.
The other machine may not be a facsimile.
A dial tone was not detected.
Communication was terminated by a cause such as
pressing the <Stop> button.
Cannot transmit manually because a line is unavailable.
execute the operation again.
Cannot use the Fax service because of causes such as
memory is insufficient.
Cannot execute another job because fax communication is
in progress.
then execute the operation again.
You attempted to change a job immediately before fax or
telephone communication completed.
The total quantity of error lines detected with G3 exceeded
the set value.
operation again. If receiving, ask the sender to send again.
This machine does not have confidential or relay function.
The F-code sent from the other machine contains an
instruction for a function not supported by the machine.
F-code.
The password was omitted or did not match in fax
communication.