Fuji Xerox apeosport-iv C5570 Administrator's Manual page 470

14 Problem Solving
Error Code
C P F S M O
016-751
016-752
016-753
016-755
016-756
016-757
016-758
O O O O
016-759
O O
016-760
14
016-761
* If you cannot resolve an error despite following the instructions described in the table, contact our Customer Support
Center. The contact number is printed on the label or card attached on the machine.
468
Category
O [Cause]
[Remedy] For 1), use the print driver to print the document.
For more information on the memory, refer to "Allocate Memory" (P.194).
O [Cause]
[Remedy] Change the [Image Quality] setting from [High Resolution]
O [Cause]
[Remedy] Set the correct password on ContentsBridge.
O [Cause]
[Remedy] Cancel the print protection using Adobe Reader, and try
O [Cause]
[Remedy] Consult your system administrator.
O [Cause]
[Remedy] Enter the correct passcode.
[Cause]
[Remedy] Consult your system administrator.
O [Cause]
[Remedy] Consult your system administrator.
O [Cause]
[Remedy] Take one of the following measures:
For more information on [Image Quality], refer to the help of the print
driver. For more information on memory, refer to "Allocate Memory"
(P.194).
O [Cause]
[Remedy] Set [Image Quality] to [Standard] and execute the
Cause and Remedy
Probable causes are as follows:
1) During the PDF Bridge processing, a syntax or
parameter error occurred, an undefined command was
used, and a PDF file was damaged.
2) When [Print Processing Mode [408])] for the PDF Direct
Print feature has been set to [PS([1])], memory is
insufficient.
3) When [Print Processing Mode [408])] for the PDF Direct
Print feature has been set to [PS([1])], a PDF file
including OpenType fonts is processed.
For 2), take one of the following measures:
Use the print driver to print the document.
Increase PostScript memory.
For 3), create a PDF file in which OpenType fonts are not
included.
Unable to process for PDF Bridge because of insufficient
memory space.
to [High Quality], or from [High Quality] to [Standard]. Or,
add memory.
The password entered does not match that of the PDF file.
Attempted to process a print-protected PDF file.
printing again.
Do not have permission to use the service.
The passcode is incorrect.
The division does not have permission to use the service.
The number of pages reached the maximum number of
pages for this service.
An error occurred during PostScript (optional) processing.
Set [Image Quality] to [High Speed].
Increase PostScript memory.
An error occurred during image processing.
operation again. If the error still is not resolved, set [Print
Page Mode] to [On].