Setting A Time Limit For Videoconferences - Avaya Scopia XT7100 Deployment Manual

Advanced Configuration of the XT Series
Field Name
Meeting/Call Time Limit
3. From the web interface only, select Save.
4. Access the bandwidth limits for each network port. From the XT Series web interface, select
Administrator Settings > Networks > GLAN1/GLAN2 > Bandwidth. From the endpoint's
main menu, select Configure > Advanced > Networks > GLAN1/GLAN2 > Bandwidth.
5. Set the fields as described in the following table:
Table 37: Configuring bandwidth settings of a call
Field Name
Enable
Max. Bandwidth Rx (KB)
Max. Bandwidth Tx (KB)
Related Links
Advanced Configuration of the XT Series

Setting a Time Limit for Videoconferences

About this task
Set a time limit for videoconferences to alert users that the time allocated for the meeting is about to
end, and to end videoconferences that were left open.
Once you set a time limit, an alert appears during the meeting when the time limit is reached. The
user can then decide to disconnect from the videoconference, postpone the reminder and extend
the meeting for another hour, or remove the time limit from this meeting. The meeting automatically
closes if there is no response to the alert after 30 seconds.
®
Avaya Scopia XT Series Deployment Guide
130
Description
Select No to disable the local audio and video and use the system
as an MCU.
See Setting a Time Limit for Videoconferences
Figure 89: Setting bandwidth limits for each network port
Description
Select Yes to enable limiting bandwidth for this network port.
Enter the incoming bandwidth limit for traffic on this network port,
measured in kilobytes (not kilobits) per second (KBps).
Enter the outgoing bandwidth limit for traffic on this network port.
on page 112
Comments? infodev@avaya.com
on page 130.
April 2015