Avaya Scopia XT7100 Deployment Manual page 88

Initial Configuration of the XT Series
2. Enter the following values:
Table 15: Configuring the IP address
Field Name
IP Address Mode or
Automatic IP Address
IP address
Subnet mask
Gateway (IP Address)
DNS (Server IP
Address)
3. Select Next and continue with one of the following, depending on whether you are
registering your endpoint to a gatekeeper or SIP server:
• If you are registering your endpoint to a gatekeeper, continue with
Gatekeeper Settings
• If you are only registering your endpoint to a SIP server (and not a gatekeeper), continue
with Configuring Basic SIP Settings
®
Avaya Scopia XT Series Deployment Guide
88
Figure 56: Defining IP Settings
Description
Determines if the IP address is dynamically allocated (using DHCP), or if
you manually designate a static IP address. You must use only static
addresses for:
®
• Scopia XT Telepresence deployments
• Units on a public network
• SIP deployments where the unit is secured with a TLS certificate.
Enter the system static IP address. For dynamic IP addresses, this field
displays the current IP address.
Enter the subnet mask associated with the IP address. For dynamic IP
addresses, this field displays the current subnet mask.
Enter the default gateway static IP address. The gateway is used to route
information between two subnets, for example, between the headquarters
and a partner site. For dynamic IP addresses, this field displays the
current gateway IP address.
Enter the DNS server IP address. The DNS server translates domain
names into IP addresses. For dynamic IP addresses, this field displays
the assigned DNS server IP address.
on page 89.
on page 90.
Comments? infodev@avaya.com
Configuring Basic
April 2015