April - Avaya Scopia XT7100 Deployment Manual

• Connect one end of the USB cable to the USB socket on the Scopia
and the other end to the upper USB connector on the XT Codec Unit. This cable also
provides power to the device, so no extra power cable is required.
Figure 30: Connecting the Scopia
3. Insert the three connectors of the camera cable (3 connectors on one side, 2 connectors on
the other side) to the sockets on the back of the camera, as shown in
cables to the back of the camera
• The DVI connector to the DVI socket
• The 8-pin connector to the IN RS232C socket
• The power connector to the DC IN 12V socket

April 2015

on page 50:
Figure 31: Connecting cables to the back of the camera
Comments? infodev@avaya.com
Connecting Cameras or DVD players
®
XT Camera Switch to the XT Codec Unit
®
Avaya Scopia XT Series Deployment Guide
®
XT Camera Switch
Figure 26: Connecting
55