Saving Ptz Camera Positions - Avaya Scopia XT7100 Deployment Manual

Table 45: Typical file sizes based on the bitrate
Bitrate
6144K
4096K
2048K
1024
512
384
3. From the web interface only, select Save.
Related Links
Advanced Configuration of the XT Series

Saving PTZ Camera Positions

About this task
You can change your PTZ camera's position before or during a call and save that position for later
use as one of several presets. You can store up to 10 positions on the new XT Remote Control Unit
from the endpoint interface, or dozens more from the web interface or using the previous XT
Remote Control Unit.
You can also recall presets for remote cameras if they support FECC. Far End Camera Control
(FECC) is a feature of endpoint cameras, where the camera can be controlled remotely by another
endpoint in the call.
Procedure
1. To recall a position and move the camera quickly to a preset:
• From the new XT Remote Control Unit, press and hold the position number.
• From the previous XT Remote Control Unit, press Select then enter the position number,
up to two digits. * indicates 10, # indicates 11.
• From the XT Series web interface, select More Actions located just under the tabs, then
select Control Camera, and press Select on the row of the position number.
April 2015
File size for 1 minute
recording
45 MB
30 MB
15 MB
7.5 MB
3.75 MB
3 MB
on page 112
Comments? infodev@avaya.com
File size for 30 minute
recording
1,350 MB
900 MB
450 MB
225 MB
112.5 MB
85 MB
®
Avaya Scopia XT Series Deployment Guide
Saving PTZ Camera Positions
File size for 1 hour
recording
2,700 MB
1,800 MB
900 MB
450 MB
225 MB
169 MB
147