Avaya Scopia XT7100 Deployment Manual page 194

Troubleshooting the Avaya Scopia
2. Press ok/menu again.
3. Select Video Source.
Connectivity
Solution
Ensure the camera is correctly connected to the system, including the VISCA cable connected to
the IN RS-232C connector on the camera.
Moving setting
The Moving setting may not be enabled.
If configuring from the endpoint, you must first enable advanced configuration, as described in
Enabling Advanced Maintenance on the XT Series
1. Access the general camera settings. From the XT Series web interface, select
Administrator Settings > I/O connections > Cameras > HD1. From the endpoint's main
menu, select Configure > Advanced > I/O connections > Cameras > HD1.
2. Make sure that the Moving field is set to Yes.
3. From the web interface only, select Save.
Related Links
Troubleshooting the Avaya Scopia
®
Avaya Scopia XT Series Deployment Guide
194
® XT Series
Figure 145: Enabling the Moving setting
®
XT Series on page 172
Comments? infodev@avaya.com
on page 112.
April 2015