Configuring The Screen Saver To Start Automatically - Avaya Scopia XT7100 Deployment Manual

Table 18: Configuring time zone related settings
Field Name
Time zone list
Enable daylight time
Start (dd/mm)
Stop (dd/mm)
3. From the web interface only, select Save.
Related Links
Configuring Basic Settings with the Quick Setup Wizard

Configuring the Screen Saver to Start Automatically

About this task
The screen saver helps to protect the endpoint's monitor from burn-in without switching it off. For
®
Scopia XT Executive with computers running the Scopia
not activate when using the computer while the endpoint is dormant. In this case, use the
computer's screen saver functionality.
Procedure
1. Access the screen saver settings. From the endpoint's main menu, select Configure >
General. From the XT Series web interface, select the Basic Settings tab.
April 2015
Configuring Basic Settings with the Quick Setup Wizard
Figure 62: Setting the time zone
Description
Select the time zone to which the system belongs.
Choose whether to enable daylight savings time.
Set the day and month to indicate when daylight saving
time starts.
Set the day and month to indicate when daylight saving
time ends. If this is earlier than the start time, it assumes
the following year.
on page 83
®
Avaya Scopia
Comments? infodev@avaya.com
XT Control utility, the screen saver does
®
XT Series Deployment Guide
95