Avaya Scopia XT7100 Deployment Manual page 57

• Attach one end of the VISCA control cable to the IN RS-232C connector on the
second camera.
• Attach the other end to the OUT RS-232C connector on the previous camera.
b. Connect the DVI-HDMI cable:
• Attach the DVI connector to the DVI socket on the second camera.
• Attach the HDMI connector to the HDMI socket labeled 2 on the Scopia
Switch.
6. If required, repeat the above step for a third or fourth HDMI device.
7. Check that the SYSTEM SELECT switch on the back panel of each camera is set to 7:
Caution:
To adjust the switch, you must first turn the camera off. Adjust it using a slotted 2.5 mm
screwdriver.
8. Turn on the XT Codec Unit by pressing the
This also turns on the Scopia
9. Connect one end of the power supply cable to the DC IN 12V connector on each camera,
and the other end into one of the power sockets on the wall.
10. Configure the cameras' settings (see
April 2015
Second Camera
XT Camera Switch
Connected to XT5000
XT Camera Switch
Connected to XT7000
Figure 34: Connecting the second camera
Figure 35: Checking the SYSTEM SELECT switch
®
XT Camera Switch.
Configuring Cameras
Comments? infodev@avaya.com
Connecting Cameras or DVD players
First Camera
power key on the XT Remote Control Unit.
on page 100.)
®
Avaya Scopia XT Series Deployment Guide
®
XT Camera
57