Connecting The Ptz Camera - Avaya Scopia XT7100 Deployment Manual

Connecting the PTZ Camera

About this task
This procedure describes how to connect the main PTZ camera to the Avaya Scopia
The XT7000 Series and the XT5000 Series use the XT Premium Camera. The XT4300 uses the XT
Flex Camera, while the XT4200 uses the XT Standard II Camera.
For details about the camera's capabilities, see
information about the room setup, see
Procedure
1. Place the camera in a position to ensure eye contact between local and remote participants.
If the XT Codec Unit is housed in a cabinet, the XT Remote Control Unit sends the signal to
the infra-red receiver of the main camera to relay messages to the XT Codec Unit. In this
case, configure the camera settings so the camera's power is always on (see
Cameras on page 100).
Try positioning the camera between the two monitors either directly above or below them, at
a distance which captures all the seats.
Caution:
Do not place the camera on top of the XT Codec Unit. It can cause the system to
overheat.
2. Remove the camera stabilizing cartons before connecting the camera to avoid damage to
the system.
3. Insert the following connectors on the camera cable to the ports on the back of the camera,
as shown in
• The DVI connector to the DVI socket
• The 8-pin connector to the IN (RS232C) socket
• The power connector to the DC IN 12V socket
April 2015
Planning the Optimal Room Setup
Figure 26: Connecting cables to the back of the camera
Comments? infodev@avaya.com
Connecting Cameras or DVD players
Technical Specifications
®
Avaya Scopia XT Series Deployment Guide
®
XT Series.
on page 18. For more
on page 42.
Configuring
on page 50:
49