Avaya Scopia XT7100 Deployment Manual page 129

2. Set the fields as described in the following table.
<auto > is the default setting. It indicates that the system tries to choose the settings that
best suit the local situation.
Table 36: Configuring bandwidth settings of a call
Field Name
IP > Rate (K)
Audio Coding
Video Coding
DualVideoCoding
Use manual DualVideo
bandwidth
DualVideo/Live bandwidth
ISDN > Rate (K)
Local audio-video
April 2015
Figure 88: Configuring general call settings
Description
Sets the maximum bitrate used for a single point-to-point call.
Sets the preferred audio codec that the system tries to send. The
remote system must support the same codec for a successful
connection.
Sets the preferred video codec that the system tries to send, if the
remote system supports the same codec.
Sets the resolution for H.264 content video.
If set to Yes allows to change bandwidth used for content and live
video (DualVideo/Live bandwidth).
Sets more bandwidth on Live Video or Content.
Sets the maximum call rate that the system uses for any ISDN call.
If using the system as an endpoint which also hosts meetings on its
built-in MCU, select Yes to include local video and audio in
videoconferences.
Avaya Scopia
Comments? infodev@avaya.com
Setting Call Bandwidth in XT Series
Table continues...
®
XT Series Deployment Guide
129