Avaya Scopia XT7100 Deployment Manual page 50

Setting Up the XT Series Hardware
4. With the camera turned off, set the System Select switch on back of the camera to 7 using a
slotted 2.5 mm screwdriver
page 50).
5. Insert the two connectors on the other end of the camera cable to the ports on the XT Codec
Unit (Figure 27: Connecting the camera cables to the XT Codec Unit
For the XT7000 Series, use the ports located under
• Connect the HDMI plug to the vertical socket.
• Connect the other plug (power) to the horizontal socket.
We recommend keeping the DVI socket available for a computer connection (for example, to
share content in a videoconference).
®
Avaya Scopia XT Series Deployment Guide
50
Figure 26: Connecting cables to the back of the camera
(Figure 26: Connecting cables to the back of the camera
Comments? infodev@avaya.com
on page 51).
on the XT Codec Unit.
on
April 2015