Control/Emissions Diagnosis (PC/ED) manual will aid in diagnosing non-transmission electronic
components.
Before Pinpoint Tests
NOTE: Prior to entering pinpoint tests, check the PCM wiring harness for tight connections, bent or
broken pins, corrosion, loose wires, correct routing, correct seals and their condition. Check the PCM,
sensors and actuators for damage. Refer to the Powertrain Control/Emissions Diagnosis (PC/ED)
manual.
NOTE: If a concern still exists after electrical diagnosis has been carried out, refer to
Diagnosis By
Symptom
in this section.
If DTCs appear while carrying out the on-board diagnostics, refer to the
Diagnostic Trouble Code
Charts
for the appropriate repair procedure. Prior to entering pinpoint tests, refer to any TSBs and
OASIS messages for transmission concerns.