Ford 2003 Mustang Workshop Manual page 2390

Shift Concerns: Some/All Shifts Missing
Possible Component
210 — ELECTRICAL ROUTINE
Powertrain Control System
· Electrical inputs/outputs,
vehicle wiring harnesses, PCM,
shift solenoids, output shaft
speed (OSS) sensor, digital TR
sensor
310 — HYDRAULIC/MECHANICAL ROUTINE
Fluid
· Incorrect level
· Condition
Shift Linkage, Digital TR Sensor
· Damaged or incorrectly
adjusted
Shift Concerns: Timing Concerns — Early/Late
Possible Component
211 — ELECTRICAL ROUTINE
Powertrain Control System
· Electrical inputs/outputs,
vehicle wiring harnesses,
PCM, shift solenoids, EPC
solenoid, TFT sensor, OSS
311 — HYDRAULIC/MECHANICAL ROUTINE
Other
· Tire size change, axle ratio
change
Fluid
· Incorrect level
· Condition
Powertrain Control System
· Engine driveability concerns
· Carry out Self-Test; refer to the Powertrain Control/Emissions
Diagnosis (PC/ED) manual for diagnosis and testing of the
Powertrain Control System.
Pinpoint Test C or Go To Pinpoint Test E
required. Clear DTCs, road test and repeat Self-Test.
· Adjust fluid to correct level.
· Inspect condition of fluid.
· Inspect and repair as required. Verify transmission shift cable
adjustment; refer to
cable as necessary. After repairing transmission shift cable,
verify that the digital TR sensor is correctly adjusted. Adjust
the digital TR sensor as necessary.
· Refer to the following shift routine(s) for further diagnosis:
Shift 1-2, Routine 220/320
Shift 2-3, Routine 221/321
Shift 3-4, Routine 222/322
Shift 4-3, Routine 223/323
Shift 3-2, Routine 224/324
Shift 2-1, Routine 225/325
· Carry out Self-Test. Refer to the Powertrain Control/Emissions
Diagnosis (PC/ED) manual for diagnosis and testing of the
Powertrain Control System.
Pinpoint Test C or Go To Pinpoint Test E
Clear DTCs, road test and repeat Self-Test.
· Verify vehicle has original equipment. Refer to Certification
Label and Safety Standard Certification Label. Changes in tire
size or axle ratio will affect shift timing.
· Adjust fluid to correct level.
· Inspect condition of fluid.
· Refer to Routine 253.
Reference/Action
Go To Pinpoint Test A
. Repair as
Section 307-05 . Adjust transmission shift
Reference/Action
Go To Pinpoint Test A
. Repair as required.
, Go To
, Go To