Ford 2003 Mustang Workshop Manual page 2249

SECTION 303-14: Electronic Engine Controls
REMOVAL AND INSTALLATION
Fuel Pressure Sensor
Material
Item
Super Premium SAE 5W-20
Motor Oil
XO-5W20-DSP or equivalent
Removal
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when
working on or near any fuel related components. Highly flammable mixtures are always present
and may be ignited. Failure to follow these instructions may result in personal injury.
WARNING: Fuel in the fuel system remains under high pressure even when the engine is
not running. Before working on or disconnecting any of the fuel lines or fuel system
components, the fuel system pressure must be relieved. Failure to follow these instructions
may result in personal injury.
Mach I
1. Remove the air intake scoop. For additional information, refer to
All engines
2. Relieve the fuel pressure. For additional information, refer to
3. NOTE: The 4.6L (4V) Cobra engine is shown, the other engines are similar.
Disconnect the connector and the vacuum line.
4. Remove the bolts and the sensor.
Specification
WSS-M2C914-
A
2003 Mustang Workshop Manual
Section 303-12 .
Section 310-00 .