Ford 2003 Mustang Workshop Manual page 2734

Hide thumbs Also See for 2003 Mustang:

Table of Contents

17. Install the third speed gear bearing spacer and the third speed bearing.

CAUTION: Before pressing the components together, verify that the synchronizer

hub faces the short end of the output shaft. Hold the third gear against the synchronizer

to maintain the synchronizer blocking ring alignment.

NOTE: If not done so previously, soak the blocking ring in MERCON® Multi-Purpose ATF

Transmission Fluid XT-2-QDX or equivalent for ten minutes.

Using a 1-1/2 inch deep well socket and a press, install the third gear, the third speed

synchronizer blocking ring, and the third/fourth gear synchronizer assembly.

Show Quick Links

Table of Contents