Ford 2003 Mustang Workshop Manual page 2653

SECTION 308-00: Manual Transaxle/Transmission and Clutch — General
Information
REMOVAL AND INSTALLATION
Dowels —Flywheel
Removal
1. NOTE: Take care not to damage the flywheel dowel holes or the surface areas around the
flywheel dowel during removal.
Remove the flywheel dowels by using a drift pin where the flywheel dowel is installed in an open
hole and a pair of locking pliers where the flywheel dowel is installed in a blind hole.
Installation
1. NOTE: Care should be taken to drive the flywheel dowel squarely into place until it is fully
seated and to not damage the surrounding surface areas.
Install all flywheel dowels by driving them into place using a brass or plastic mallet.
2003 Mustang Workshop
Manual