Ford 2003 Mustang Workshop Manual page 1926

SECTION 303-04A: Fuel Charging and Controls — 3.8L
REMOVAL AND INSTALLATION
Fuel Charging Wiring Harness
Removal and Installation
WARNING: Do not smoke or carry lighted tobacco or open flame of any type when
working on or near any fuel related components. Highly flammable mixtures are always present
and may ignite. Failure to follow these instructions may result in personal injury.
1. Disconnect the battery ground cable. For additional information, refer to
2. Remove the upper intake manifold. For additional information, refer to
3. Disconnect the following electrical connectors.
42-pin engine bulkhead connector
16-pin connector
8-pin connector
A/C pressure switch
4. Separate the wiring harness from the dash panel.
5. Disconnect the intake manifold runner control (IMRC) actuator electrical connector.
2003 Mustang Workshop Manual
Section 414-01
Section 303-01A
.
.