SECTION 303-14: Electronic Engine Controls
REMOVAL AND INSTALLATION
Mass Air Flow (MAF) Sensor —3.8L
Removal
CAUTION: The mass air flow (MAF) sensor hot wire sensing element and housing are
calibrated as a unit and must be repaired as a complete assembly. Do not damage the sensing
element (internal to housing) or possible failure to the mass air flow sensor may occur.
1. Disconnect the battery ground cable. For additional information, refer to
2. Remove the air cleaner and duct assembly. For additional information, refer to
3. Release the four tabs and remove the mass air flow (MAF) sensor.
4. Disconnect the connector.
5. Remove the mass air flow sensor (MAF).
Remove the nuts and the MAF sensor.
2003 Mustang Workshop Manual
Section 414-01
Section 303-12
.
.