SECTION 303-13: Evaporative Emissions
REMOVAL AND INSTALLATION
Evaporative Emission Test Port
Removal and Installation
1. Disconnect the pin-type retainer.
2. Raise and support the vehicle. For additional information, refer to
3. Remove the RH front wheel. For additional information, refer to
4. Remove the RH front splash shield.
1. Remove the three screws.
2. Remove the five pin-type retainers.
5. Remove the evaporative emission test port by disconnecting at the EVAP canister purge outlet
tube junction.
6. To install, reverse the removal procedure.
2003 Mustang Workshop Manual
Section 100-02
.
Section 204-04
.