Ford 2003 Mustang Workshop Manual page 2597

Test Step
B1 CHECK THE SHIFT
CONTROL LINKAGE
Key in ON position.
Apply the brake pedal.
Actuate the transmission
range selector lever in all
ranges.
Observe the shift control
linkage during operation.
Is the shift control linkage
OK?
B2 CHECK THE TRANSMISSION
SHIFT CABLE
Check the transmission shift
cable and bracket installation
and tightness.
Is the transmission shift
cable correctly installed
and adjusted?
B3 CHECK THE
LINKAGE/CABLE FOR CORRECT
GEAR RELATIONSHIP
Apply the brake pedal.
Actuate the transmission
range selector lever in all
ranges.
Does the indicator match
the gear selection?
PINPOINT TEST C: THE TRANSMISSION CONTROL SWITCH (TCS)
IS INOPERATIVE
C1 CHECK THE VOLTAGE TO THE TRANSMISSION CONTROL
SWITCH
Key in OFF position.
Disconnect: Transmission Control Switch C279.
Key in ON position.
Measure the voltage between TCS C279-3, Circuit 911
(WH/LG), harness side and ground.
Yes
GO to B2 .
No
REPAIR as necessary. TEST the system for normal
operation.
Yes
GO to B3 .
No
REPAIR as necessary. TEST the system for normal
operation.
Yes
VERIFY the correct adjustment of the digital transmission
range (DTR) sensor. REFER to
digital DTR sensor if necessary. TEST the system for
normal operation.
No
ADJUST the transmission shift cable. REFER to
Adjustment . TEST the system for normal operation.
Test Step
Result / Action to Take
Section 307-01
Result / Action to Take
Yes
GO to C2
No
REPAIR the circuit. TEST
the system for normal
operation.
. Adjust the
Cable
.