Ford 2003 Mustang Workshop Manual page 2052

SECTION 303-06: Starting System
REMOVAL AND INSTALLATION
Starter Motor —3.8L
Removal
WARNING: When servicing starter motor (11002) or carrying out other underhood work in
the vicinity of the starter motor, be aware that the heavy gauge battery input lead at the starter
solenoid (11390) is "electrically hot" at all times. A protective cap or boot is provided over this
terminal that must be installed after servicing. Be sure to disconnect the battery negative cable
before servicing the starter. Failure to follow these instructions may result in personal injury.
WARNING: When working in area of the starter motor, be careful to avoid touching hot
exhaust components. Failure to follow these instructions may result in personal injury.
NOTE: When working on the starter system, make sure the anti-theft system is deactivated (if
equipped.)
1. Disconnect the battery ground cable. For additional information, refer to
2. Raise and support the vehicle. For additional information, refer to
3. Remove the ground cable nut.
4. Remove the cap.
5. Remove the nuts and position aside the wires.
2003 Mustang Workshop Manual
Section 414-01
Section 100-02 .
.