Ford 2003 Mustang Workshop Manual page 2654

SECTION 308-00: Manual Transaxle/Transmission and Clutch — General
Information
REMOVAL AND INSTALLATION
Dowels —Flywheel Housing to Block
Removal
1. NOTE: Take care not to damage the flywheel housing to block dowel holes or the surface areas
around the flywheel housing to block dowel hole during removal.
Remove the two flywheel housing to block dowels using a drift pin where the flywheel housing
to block dowel is installed in an open hole and a pair of locking pliers where the flywheel
housing to block dowel is installed in a blind hole.
Installation
1. NOTE: Care should be taken to drive the flywheel housing to block dowel squarely into place
until it is fully seated without damaging the surrounding surface areas.
Install all flywheel housing to block dowels by driving them into place using a brass or plastic
mallet.
2003 Mustang Workshop
Manual