SECTION 303-07B: Engine Ignition — 4.6L (2V)
REMOVAL AND INSTALLATION
Ignition Coil —Coil On Plug
Removal
1. Disconnect the battery ground cable (14301). For additional information, refer to
01
.
2. Remove the air cleaner outlet tube (9B659). For additional information, refer to
3. NOTE: One ignition coil is shown, and the others are similar.
Disconnect the connector from the ignition coil (12029).
4. Remove the bolt and the ignition coil.
Installation
1. NOTE: Verify the ignition coil spring is correctly located inside the ignition coil boot and there is
no damage to the tip of the boot.
To install, reverse the removal procedure.
2003 Mustang Workshop Manual
Section 414-
Section 303-12
.