Ford 2003 Mustang Workshop Manual page 2041

12, circuit 33 (WH/PK) and the starter motor relay pin 86, circuit
33 (WH/PK).
Is the resistance less than 5 ohms?
B4 CHECK DIGITAL TRANSMISSION RANGE (TR) SENSOR
ADJUSTMENT
Carry out the digital TR sensor adjustment. Refer to
307-01 .
Is the digital TR sensor adjusted correctly?
B5 CHECK CIRCUIT 32 (RD/LB) FOR VOLTAGE AT THE CLUTCH
SWITCH OR JUMPER
Key in OFF position.
Disconnect: Clutch Pedal Switch C255.
Key in START position.
Measure the voltage between the clutch pedal switch C255 pin
2, circuit 32 (RD/LB) and ground while holding the key in the
START position.
Is the voltage greater than 10 volts?
B6 CHECK CIRCUIT 33 (WH/PK)/32 (RD/LB) FOR OPEN
Key in OFF position.
Measure the resistance between the clutch pedal switch C255
pin 1, circuit 33 (WH/PK)/32 (RD/LB) and the starter motor relay
pin 86, circuit 33 (WH/PK)/32 (RD/LB).
Is the resistance less than 5 ohms?
B7 CHECK FOR VOLTAGE AT FUSE 6
Key in OFF position.
Disconnect: Fuse #6.
Key in START position.
Yes
Section
INSTALL a new digital
TR sensor. TEST the
system for normal
operation.
No
ADJUST the digital TR
as necessary. TEST the
system for normal
operation.
Yes
GO to B6
No
GO to B7
Yes
INSTALL a new clutch
pedal switch. TEST the
system for normal
operation.
No
REPAIR circuit 33
(WH/PK)/32 (RD/LB).
TEST the system for
normal operation.
Yes
REPAIR circuit 32
(RD/LB). TEST the
.
.