Ford 2003 Mustang Workshop Manual page 2426

SECTION 307-01: Automatic Transaxle/Transmission
IN-VEHICLE REPAIR
Main Control Valve Body
Special Tool(s)
Gauge, Transmission Solenoid
Connectors
307-426
Removal
1. Drain transmission fluid and remove the transmission fluid pan and filter. For additional
information, refer to
2. CAUTION: Do not pull on the molded lead frame. This may cause damage to the
connector ends. Carefully pry up on the locking tabs to disconnect the solenoids.
Disconnect the molded lead frame from the solenoids.
Disconnect the molded lead frame from the solenoids.
1. Disconnect the shift solenoid SSA and SSB.
2. Disconnect the torque converter clutch (TCC).
3. Disconnect the electronic pressure control (EPC) solenoid.
4. Disconnect the bulkhead inter-connector.
3. Remove the manual control valve detent lever spring.
1. Remove the bolt.
Fluid Pan, Gasket and Filter
2003 Mustang Workshop Manual
.