SECTION 303-08: Engine Emission Control
REMOVAL AND INSTALLATION
Exhaust Gas Recirculation (EGR) Valve —Mach I
Removal and Installation
1. Remove the air intake scoop. For additional information, refer to
2. Remove the exhaust gas recirculation (EGR) valve.
1. Disconnect the EGR tube upper fitting.
2. Disconnect the vacuum hose.
3. Remove the two bolts and remove the EGR valve and gasket.
3.
CAUTION: Do not use metal scrapers, wire brushes, power abrasive disks or other
abrasive means to clean the sealing surfaces. These tools cause scratches and gouges,
which make leak paths. Use a plastic scraping tool to remove all traces of old sealant.
Clean and inspect the mating surfaces.
4. To install, reverse the removal procedure.
Install a new gasket.
2003 Mustang Workshop Manual
Section 303-12
.