Clutch
Clutch
Disassembly
1.
Remove the rider's seat (see page 16- 13).
2 .
Disconnect the battery, negative (black> lead first.
3 .
Release the clutch cable from t h e actuating arm (see
page 4-S>.
4.
Remove the clutch cover. Discard the clutch cover
gasket.
1. Clutch pull-rod
2. Outch pressure plate
Z
Remove the clutch friction plates and steel plates
together with the anti-judder spring and anti-judder
seat washer.
4.6
SeNice Manual
-
Tiger 800 and Tiger SOOXC
Note:
•
Record the orientation of all components as
they are
removed.
assembled in the same order.
dpb
1. Steel plate
2. Inner fiction plate
3. Anti-judder spring
4. Anti-judder seat washer
5. Clutch inner drum
Note:
•
The inner and outermost friction plates are
different to the remainder and are also
different to each other. They must be fitted
in their noted positions.
•
The
three
outer
different to the other plates, depending on
the clutch pack height settings used during
manufacture <see page
fitted in their noted positions.
•
Store all plates in their correct fitted order
to avoid confusion on installation.
•
Refer to the following page of this section
for details of clutch friction plate checking.
•
lt is not normally necessary to disassemble
the clutch further, but if the clutch inner and
outer drums are to ·be removed, proceed as
follows:
The
plates
must be
steel
plates
may
be
4-B>.
They must be