Water Pump; Coolant Pressure Cap And Coolant System; Inspection And Testing - Triumph 2012 Tiger 800 Service Manual

Water Pump

Note:
•
The oil pump and water pump are supplied
as an assembly and cannot be separated. For
additional information, refer to Oil Pump
8-8
<see page for removal and page
for installation>.
8-13
-
Service Manual Tiger 800 and Tiger 800XC
Coolant Pressure Cap and Coolant
System Testing

Inspection and Testing

!
Do not remove the coolant pressure cap when the
engine is hot. When the engine is hot, the coolant inside
the radiator is hot and also under pressure. Contact with
the pressurised coolant will cause scalds and skin
damage.
1. Allow the engine temperature to cool for at least 30
minutes.
2. Remove the coolant pressure cap.
3. Check the condition of the u pper and lower seals of
the coolant pressure cap.
caw r
1. Lower seal
2. Upper seal
3. Spring
Note:
•
If there is any
deterioration replace the cap.
4. Pressure test the cap and cooling system to the blow
off pressure of 1.1 bar as described below using
T3 88014Z If the cap opens at a lower pressure or
fails to open at 1.1 bar, replace the ca p.
Note:
•
lt is recommended to carry out coolant
pressure cap and cooling system pressure
tests consecutively.
Cooling
sign of damage or
11.7