Abs Warning Light On <No Dtcs Stored) - Triumph 2012 Tiger 800 Service Manual

ABS Warning Light ON <No DTCs Stored)
Fault Code
ABS Wa rn ing Light O N <No DTCs ABS Ign ition supply fuse/circuit fa ult
Stored)
Pinpoint Tests
Test
1 Check cable and term inal i ntegrity:
- ABS ECM connector pin 16 and G round
pin 24
2 Check ca ble contin u ity of the ABS ignition
supply ci rcu it: With I g n ition ' O N ', check
voltage between
- ABS ECM connector pin 16 and G round
3
Check cable continu ity of the ABS warn ing
light circu it:
Check voltage between :
- ABS ECM connector pin 21 and G round
4 Check cable continuity of the ABS warn ing
light circuit: - Short ABS ECM connector pin
21 and G round pin 24 together:
Turn Ign ition ' O N '
5
Reconnect ABS ECM harness, clear fault
code and test ABS to verify fa ult cleared
Circuit Diagram
Headlamp Relay
Possible cause
ABS Wa rn ing light ci rcu it fa u lt
Result
OK
Fa ulty
Same
battery' voltage
Less than
battery' voltage
Voltage g reater than
1 . 5 V
Voltage
1 . 5 V
ABS warning
'OFF'
ABS wa rning
' O N '
O K
Fa ult still present
Se1Vice Manual Tiger 800 and Tiger 800XC
-
Action
Ensu re ABS ECM connector is secu re.
Disconnect ABS ECM connector and
proceed to pinpoint test 1 :-
Action
Proceed to test 2
Rectify fault, proceed to test 5
as Proceed to test 3
'across
Locate and rectify wiring fault, proceed to test
'across
5
Proceed to test 4
less than Locate and rectify fa u lt, proceed to test 5
light Proceed to test 5
Locate and rectify fa ult, proceed to test 5
light
Action complete - q u it test
Contact Tri umph service
Rear Fuse Box
� --- -·
y
R
_L
Bra kes
ABS
Control Module
8
9
16
21
25
14.55