Triumph 2012 Tiger 800 Service Manual page 289

1 3 . Click the Adjust button.
Adjust T une Procedure
Adjust the throttle balance as described i n the service manual until
balanced
Press cancel to cancel the adjustment process
OK
Press to finish
Throttle Status :
Cyl inder 1 MAP Pressu re :
Cyl inder 2 M A P Pressu re:
3
Cyl inder MAP Pressu re :
Adjusti ng parameter - Balance Throttles
Balance Throttles Screen
Note:
•
The balance throttle screen will show the
vacuum value of each throttle in mm/ Hg. In
addition, when the throttles are balanced to
an acceptable range of each other the word
'THROTTLES BALANCED' in green text will
appear on the right of the screen. At this
point, no further adjustment is necessary or
productive.
•
If the throttles are not balanced to each
other the
U N BALAN CED' in red text will appear on
the right of the
adjustment will be necessary.
•
The adjusters operate on the outer cylinders
only <cylinders 1 and 3). The centre throttle
(cylinder 2) adjustment is fixed, this being
controlled by the idle speed control stepper
motor. Note that the centre reading will
alter slightly as the two outer cylinders are
adjusted.
•
DO N OT attem pt to
throttle stop screw, located below the idle
stepper motor. The stop screw is set at the
factory during manufacture, and must not
be adjusted.
Throttles Balanced
480 mmHg
481 mmHg
480 mmHg
word 'TH ROTTLES
screen. At this point
adjust the centre
SeiVice Manual Tiger 800 and Tiger 800XC
-
Fuel System/Engine Management
14. Using the throttle adjusters, make adjustments to the
two outer cylinders u ntil the word 'TH ROTILES
BALAN CED' in green text appears.
1. Adjusters
1 5 . When balanced, stop the engine a n d disconnect the
diagnostic tool.
16. Disconnect the fuel pressure gauge adapter and
wiring extension.
1Z Refit the airbox <see page
18.
Refit the fuel tank <see page
19. Remove the exhaust extraction hoses from the
silencer.
20. Refit the rider's seat <see page
10-101).
·
10-92).
16-13).
10. 1 1 1