Connecting Rod Bearing Selection
Minor
differences
in
crankshaft
compensated for by using selective bearings. For further
information
on
bearing
cross-references, see the latest parts information.
1.
Select the correct big end bearing shell as follows:
Measure eac h cra nkshaft journal dia meter.
Select the co r rect bearings by matching the
•
i nformation found with the chart below.
Note:
All dimensions in millimetres.
•
Big end bearing selection chart
Shell Colour
White
Con-rod Big End
3 6.009
Bore Dia.
3 6.000
Crankshaft Journal
3 3 .000
Dia.
3 2 .992
Running
Clearance
For instance:
Con-rod Big End Diameter
Crankshaft Journal Diameter
Required Bearing
Note:
Repeat the measurements for all connecting
•
rods
and
their
journals.
lt is normal for the bearings selected to
•
differ from one connecting rod to another.
Crankshaft, Connecting Rods and Pistons
dimensions
are
part
num ber
to
colour
Red
3 6.009
3 6.000
3 2.991
3 2.984
0.065
0.03 5
3 6.002
3 2.987
Red
respective
crankshaft
Service Manual
Tiger 800 and Tiger 800XC
-
2.
Install the new bearings in the connecting rod.
1
cdmx
1. Big end bearings
Always confirm, using the Plastigage method, that the
running clearance is correct before final assembly.
Severe engine damage could result from incorrect
clearance.
5.11