Triumph 2012 Tiger 800 Service Manual page 394

Brakes
1 1. Remove the fixing and detach the battery negative
cable form the upper crankcase.
cgyw
1. Battery negative cable
2. Fixing
12. Remove the rear brake light switch and disconnect
the rear master cylinder hose at the master cylinder.
Discard the sealing washers.
Before the disassembly of any brake lines in the ABS
hydraulic circuit, always mark their position so that they
can be returned to the same position when assembled.
If the brake lines are incorrectly assem bled the
performance of the ABS system wil l be seriously
compromised, leading to loss of motorcycle control and
an accident.
1 3 . Detach the th ree front brake hard line clips from the
fra me.
1. Front brake hard lines
2. Clips
14.40
SeNice Manual Tiger 800 and Tiger 800XC
-
14. Remove the left hand lower ABS modulator fixing,
located under the front seat bridge.
2. Left hand lower fixing
1 5 . Remove the right hand lower A B S modulator fixing,
located under the rear mudguard.
cgyx
1. Right hand lower ABS modulator fixing
2. Rear brake fluid reservoir
Do not allow the brake hard lines to become bent or
kinked during ABS mod ulator removal.
If the brake lines are bent or kinked the performance of
the ABS system wil l be seriously compromised, leading
to loss of motorcycle control and a n accident.
Note:
•
The battery negative cable is routed
between the ABS modulator and the
bracket, and is removed at the same time as
the modulator assembly.