Installation - Triumph 2012 Tiger 800 Service Manual

Lubrication

Installation

1. Incorporating new 0-rings (two each end of the
tube), position the water pump drain tube to the oil
pump.
1 . Water pump drain tube
2. 0-rings
2.
Incorporating a new sump gasket/baffle, position the
sump to the lower crankcase.
3. Tighten the sump fixings to
8.16
12 Nm.
SeNice Manual Tiger 800 and Tiger 800XC
-
5. Refit the sump guard bracket and secure with the
three fixings. Tighten to
1. Sump guard bracket
2. Fixings
6. Refit the sump guard (see page
Note:
Use new exhaust gaskets at the downpipe
•
connections with the cylinder head.
Z Fill the engine with the correct grade of engine oil
<see page 8-6>.
8.
Reconnect the battery, positive <red> lead first.
9. Start the engine and ensure that the low oil pressure
warning light goes out shortly after starting.
10. Stop the engine and check the engine oil level.
Adjust if necessary (see page 8-6) .
1 1. Refit the rider's seat <see page
15 Nm.
16-2T > .
.
16- 13).