Disassembly
1.
Detach the rubber boot from the lever end of the
cylinder.
2.
Remove the circlip from beneath the boot.
1. Circlip
3 .
Remove the piston set from the master cylinder bore
noting the relative position of the seals and piston
components.
cequ
1. Master cylinder
2. Spring and piston assembly
3. Circlip
4. Rubber boot
1
Service Manual
Tiger 800 and Tiger 800XC
-
Inspection
1.
Check the following for wear, damage, cracks or
deterioration:
•
Cylinder bore
Rubber boot
•
Spring
•
Piston
•
Pivot Bolt
2.
Always renew the piston and seal set if the cylinder is
dismantled.
3.
Check that the two ports in the master cylinder bore
are not blocked.
ceqq
1. Ports
Brakes
14.21