Triumph 2012 Tiger 800 Service Manual page 332

Rear Suspension
20. Retain the tool body and tighten the large pressure
screw until the split link end is riveted-over.
cdqn
1. Tool body
2. Large pressure screw
3. Flare pin
21. Back off the large pressure screw and rivet the
remaining split link pin as described above.
12.18
SeNice Manual Tiger 800 and Tiger 800XC
-
22.
Remove the tool from the chain and check that
split link
both the pins a re correctly riveted as
shown below.
1 2
cana
Correct riveting
1 .
Insufficient riveting
2.
Excessive riveting
3.
Riveting off-centre
4.
If either s p l it l i n k p i n is not correctly riveted , the split
link must be removed and replaced with a n ew link.
N ever operate the motorcycl e with an incorrectly
riveted split l i n k as the l i n k could fai l resu lti ng in an
u nsafe riding condition lead i n g to loss of control and
an accident.
4
3