Inspection; Installation - Triumph 2012 Tiger 800 Service Manual

Wheels/Tyres

Inspection

!
Only remove raised witness marks from with i n the
wheel. Removal of material below any raised a reas will
reduce the level of interference between the wheel and
the bearings. Loss of interference could cause the
bearing to become loose i n the wheel leading to loss of
motorcycle control and a n accident.
1 . Examine t h e wheel for a n y raised witness marks
caused by the removal process. Remove a ny such
marks with fine emery paper or a gentle file.

Installation

Note:
•
Refer to the chart below for the correct tool
and tool face when
Bearings are inserted by means of a draw­
bolt acting on the insertion tool. A support
tool is located on the opposite side of the
wheel to the insertion tool and as the bolt is
tightened, the bearing is drawn into the
wheel.
•
Insert bearings with the marked or shielded
side facing outwards and always
bearing circlip and seals.
Bearing insertion
tool
Left bearing T3 8800 5 3
La rge face
bea ri n g
Right bearing T3 8 8 0 0 5 3
La rge face
bearing
15.16
inserting bearings.
fit
a new
Su pport tool
3 8 80070 - T03 01
to
to Large face
Wheel
3 8 8 0070 - T03 01
to Large face to
wheel
-
Service Manual Tiger 800 and Tiger SOOXC
1. Fit the wheel bearings and centre sleeve using the
method described on the previous page.
1. Tool T388005 3
2. Fit a new circl ip.
3. Lubricate and fit new sea ls to the
Lub ricate the seal's knife-edge with g rease to N LG I 2
specification <we reco mmend Mobil H P2 2 2).
4. Fit the rear wheel (see page 15- 12>.
(
rear wheel.