Rear Mudguard; Removal - Triumph 2012 Tiger 800 Service Manual

Frame and Bodywork

Rear Mudguard

Removal

1 . Remove the rider's seat <see page 16- 13).
2 . Disconnect t h e battery, negative <black) lead first.
3 . Remove the rear rack <see page 76-20>.
4. Remove the rear side p
Note:
•
The reflector bracket is secured by a nut and
bolt located behind the licence plate in all
markets where a mudguard extension is not
required by law.
•
The rear mudguard
instead of the splash guard in certain markets
as standard, or is available as an accessory from
your Triumph dealer. The mudguard extension
uses the same fixings as the splash guard
shown below, with the addition of a third fixing
behind the licence plate.
1 . Remove the two lower splash guard or mudguard
extension fixi ngs located u nder the rear m udguard .
1.
Splash guard (mudguard extension is similar)
2. Fixings
2 .
For models fitted with a mudguard extension:
Remove the lower fixin g located behind the licence
plate.
3 . Remove the two u p per fixi ngs located
All models:
behind the licence plate.
16.22
a
nels <see page 16-2 1).
extension is installed
SeiVice Manual
-
4. Remove the splash guard or mudguard extension.
1.
Fixings
2. Mudguard extension or reflector bracket fixing (only if
fitted>
>-'
5. Noting the cable
d i rection indicator con nectors.
6. Remove the two seat rai l fir-tree cli ps.
1.
Rear mudguard
2. Fir-tree clip
Tiger 800 and Tiger 800XC
routing, d iscon nect the rear