Headstock Bearing Removal - Triumph 2012 Tiger 800 Service Manual

9. Refit the top yoke assembly to the forks.
10. Tighten the top nut to 90 Nm.
1 1. Tighten the top yoke clamp bolts to
12. Locate the handlebar assembly in the lower halves of
the clamps. Fit the upper clamps and 10 mm bolts.
1 3 . Rotate the handlebar so that the etched centre
<longer) marking on the handlebar aligns with the
split line on the u pper damps/risers.
14. Tighten the 10 mm bolts to
1. Upper clamp
2. Clamp split line
3. Centre marking
15. Refit the 8 mm bolts to the and tighten to
16. Recheck the bearing adjustment <see page
2 0 Nm.
35 Nm.
26 Nm.
13- 15).
SeNice Manual Tiger 800 and Tiger 800XC
-
Front Suspension

Headstock Bearing Removal

Before starting work, ensure the motorcycle is stabilised
and adequately supported. Th is will hel p to prevent it
falling and causing injury to the operator or damage to
the motorcycle.
1. Remove both forks <see page
Care must be taken when removing the headstock top
nut, to ensure that the top nut and headstock do not
become scratched. Protect the surfaces with a suitable
cloth or tape to prevent scratching.
2. Remove the headstock top nut.
1. Headstock top nut
3 . A s an assembly, raise t h e top yoke and handle bars
until clear of the steering stem. Rest the assembly
forward of the steering stem such that access to the
adjustment nuts is un restricted. Ensure the master
cylinder remains in an u pright position.
13-S>.
13. 17