Flash Detection Time - Siemens HiPath 1100 Programming Manual

Programming an extension
Step by step
ejl
d . f
ege
dde . fid
76
The Dialing mode designates the dialing method as
pulse (DP), tone (DTMF) or automatic detection.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the extension number (e.g., 12/102).
w
Enter the code for the dialing mode:
d
= Automatic identification (default)
e
= Pulse (DP)
f
= Multifrequency (MF)
w
p
Enter the next extension number
or
w
r
Press this key.
Initial status for programming mode.

Flash detection time

The Flash detection time is the maximum period of
time required by a PABX to detect a flash signal gener-
ated by an internal telephone. If older MF dialing tele-
phones are connected to the system, it may be neces-
sary to adjust the Flash detection time to their response
times (see manufacturer's instructions). The specified
Flash detection time may vary for different countries.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the extension number (e.g. 12/102).
Enter the Flash detection time (001 to 250, in cycles of
10 ms). 001 = 10ms ... 010 = 100 ms ... 035 = 350 ms,
etc.
Default:
•
•
•
w
p
Enter the next extension number.
or
035 - Portugal, Argentina and Thailand
036 - for Korea
028 - for all other countries.