Tme1 Module - Siemens HiPath 1100 Programming Manual

Setup and Installation

TME1 module

The TME1 module can only be installed in slot 3 (
U
P0/E
The HiPath 1150 the U
order to use a U
MB (
226
Warning: Do not touch the administration serial interface connector
of the TME1 module before disconnecting all analog extensions and
external line connectors. Failure to follow this procedure may ex-
pose the user to dangerous voltages. The TME1 module intercon-
necting cables and connectors should only be handled by qualified
technical personnel.
Module
P0/E
module you must install a CTR-U
P0/E
page 219).
module can only be installed in Slot 1 or 2. In
page 219).
module on the
P0/E