Call Forwarding Within A Call Group (Cg) - Siemens HiPath 1100 Programming Manual

Step by step
eeg
w
p
eeg
fff
q
In the default configuration the first 10 extensions in Hi-
Path 1100 systems belong to Call group 770.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the Call group number (770 to 779).
w
. p
Enter the extension numbers (up to 10 extensions -
e.g., 11/101) to be included in the subscriber group.
w
r
Press this key.
Initial status for programming mode.
Deleting extensions from a Call group (CG)
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the Call group number (770 to 779).
w
q
All extensions belonging to the Call group selected are
deleted.
w
r
Press this key.
Initial status for programming mode.

Call forwarding within a Call group (CG)

This feature works only on digital lines. It provides call
forwarding for extensions belonging to Call groups.
When a call is routed to a Call group, it rings at all exten-
sions at the same time. The extension configured for
call forwarding will ring at its destination. If the call is an-
swered, the other extensions in the group stop ringing.
Otherwise, the call rings again until one of them an-
swers it.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
r
or
Activate/Disable call forwarding:
q
= Activated
r
= Deactivated (default)
An extension can be configured for more than
one Call group (CG).
Programming an extension
55