Billing; Call Charge Unit; Multiplier For Call Charge Factor - Siemens HiPath 1100 Programming Manual

Step by step
emi
A callback can only be scheduled for an MSN.
MSN numbers must be programmed and must
have attendants.

Billing

On HiPath 1100 systems, the Billing facility (Call
cost limit by extension) is only available for digital
trunks (ISDN and CAS). Please consult your local
carrier to know if this service is provided.

Call charge unit

To show call charges in currency units you must specify
a call charge factor. Pulses are multiplied by this factor.
A call charge unit consists of a pulse transmitted to the
public exchange, over the line, that displays call charge
information according to the type of line (external or IS-
DN), call type (local, DDD, International, etc.) and other
parameters specified by the carrier.
The default value is the "0" comma slot and the "00001"
factor.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
p
Set the call charge factor (9 digits).
p
Enter the decimal separator position (0 to 3)
Examples:
– for R$ 0.12: 000000012 and 2 (comma position)
– for R$ 2.00: 00002 and 0 (comma position)
– for R$ 123456.789: 123456789 and 3 (comma po-
sition)
w
Initial status for programming mode.

Multiplier for call charge factor

This setting specifies the multiplier for call charge fac-
tors.
General settings
105