Time For Sw Update; External Number For Updating The Software; Frequency For Sw Update - Siemens HiPath 1100 Programming Manual

General settings
Step by step
dil
dij
dik
de . ef
110

Time for SW Update

This setting specifies the time of day for starting the
data transfer on the specified day.
The default setting specifies the time for the update
process at 00:00 hours.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
p
Enter the hour (00 to 23) and the minutes (00 to 59) for
starting the update.
w
Initial status for programming mode.

External number for updating the software

This setting specifies a number to be used by the sys-
tem to update the software.
The default configuration does not specify any number.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the external numbers (up to 20 digits).
w
r
Press this key to finalize the entry.
Initial status for programming mode.

Frequency for SW Update

This setting specifies regular intervals in months for
transferring data. During a transfer the telephone oper-
ates as usual.
The default setting specifies updates to be done in a
monthly basis.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
Enter the time period for performing updates (01 to 12)
where 01 = every month (default) ... 12 = update every
12 months, on a specified day of the month.