Analog Line Attendants - Siemens HiPath 1100 Programming Manual

Important settings
Step by step
ehf
24
w
r
Press this key.
Initial status for programming mode.

Analog line attendants

If you want calls received over analog trunks to ring at
specified extensions at certain times of the day, all you
need to do is configure them as analog line attendants.
Any extension can also be configured as a second atten-
dant. In this case an extension only receives a call when
the external line answering extension does not answer
the call within a specified time (
occurs, extensions configured as second attendants for
external lines receive the call along with the first atten-
dants.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter a number for an analog trunk (e.g., 801).
e h
Select the period of the day for answering calls:
...
e
= Day
f
= Night
g
= Day service, second attendant
h
= Night service, second attendant
Example:
801 and 802 external lines are programmed as
part of the 890 group of lines.
When using code 002, Extension 11/101 is as-
signed to group 890. This means that when the
"0" access code is entered at this extension a
search for a free line is performed in group 890.
For code 002, when extension 11/101 is assigned
to group 0 and the external access code "0" is di-
aled, the search for an available line is done on
group "0."
If no available line is found and the group is pro-
grammed with code 099 "Overflow for a group of
external lines" on page 42, it will search for a line
in a different specified group.
page 53). When this