General settings
Step by step
dim
eld
112
Uploading the SW update
This setting specifies when the data downloaded will
be uploaded to the system's memory.
While this upload is in progress (lasting approximately 3
minutes), the telephone remains out of service.
The default setting specifies for data to be transferred
at 00:00 hours.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
p
Enter the hour (00 to 23) and the minutes (00 to 59) for
starting the uploads.
w
Initial status for programming mode.
Setting a System Password
Access to the system's programming mode is protect-
ed by password to prevent unauthorized access. The
default password is "31994." This password can be
changed.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter a new system password (5 digits).
w
p
Confirm the new password by entering it again (5 dig-
its).
w
Initial status for programming mode.
Make a note of the new password and store it in
a safe place. If you forget the password, the only
way to access programming mode is by asking a
support technician to give you access.
Night service password