Timeout Within A Hunt Group; Call Forwarding Within A Hunt Group (Hg) - Siemens HiPath 1100 Programming Manual

Step by step
fhf
de . fh
ffg
q

Timeout within a Hunt group

This sets a time interval in which the external or internal
call must be answered by the member of the group. Dif-
ferent times may be set for each group. If the call for-
warding times out before the member of the group an-
swers, the call will ring consecutively in the other free
extensions of the group.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the Hunt group number (780 to 789).
Enter the length of time (01 to 24 in cycles of 5 seconds)
where 01 = 5 seconds... 04 = 20 seconds (default).
w
Initial status for programming mode.

Call forwarding within a Hunt group (HG)

This feature only works for digital lines. It provides call
forwarding for extensions belonging to Hunt groups.
When a call is directed to a group, it rings at each exten-
sion, according to the group settings (linear or round-
robin) When an extension is set for call forwarding, calls
are routed to the destination as configured. If a call is
not answered, the other extensions in that group do not
ring. When no call forwarding is set, calls ring at the oth-
er extensions, as configured for the Hunt group.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
r
or Activate/Disable call forwarding:
q
= Activated
r
= Deactivated (default)
w
Initial status for programming mode.
The Hunt group will not be forwarded or over-
flow if the call is not answered.
Programming an extension
67