Call Charge Factor For Extensions; Call Charge Value By Extension - Siemens HiPath 1100 Programming Manual

General settings
Step by step
dhf
e
ddd . fih
dhg
e . g
106
The default setting specifies that each pulse be multi-
plied by 1 for both factors.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
f
Select a call charge factor:
or
e
= Factor 1
f
= Factor 2
w
Select a pulse multiplier.
w
Initial status for programming mode.

Call charge factor for extensions

This setting specifies whether there is a factor for billing
the users.
Required: Programming mode must be activated (*95
31994).
w
Enter the programming code.
w
p
Enter the extension number (e.g. 11/101).
w
Select a billing factor for the extension:
e
= Default - equivalent to the billing value x1 (default)
f
= Factor 1
g
= Factor 2
w
p
Enter the next extension number.
or
w
r
Press this key.
Initial status for programming mode.

Call charge value by extension

This setting specifies the monthly amount that each ex-
tension can spend.
The default value is the "0" comma slot and the "00001"
factor.
Required: Programming mode must be activated (*95
31994).